Neve 34128 rack of eight complete and ready for service.
Front panel installed
Neve PSU Installed
Neve phantom power switch wiring.
Bus wires for ground and power.
Power Supply installed and ready for wiring.
Neve rack wiring finished!
15 Pin EDAC connectors installed & ready for wiring.
The JLM power supply PCB, assembled and ready for installation.
The power supply PCB mounted and ready for installation. The holes you can see will screw the assembly to the side of the case, making the case itself a heatsink for the voltage regulators.
JLM Audio Regurgitator PCB stuffed and ready for installation.
Separate the pins using a cutting disk on a Dremel type tool. Using one with variable speed, set to as slow as possible will make the job easier. You only need to skim off the excess PCB trace between pins C & D.
Pins C & D need to be separated. You can see them in their original form – third gold pin from the right in the photograph.
The rear panel XLR connectors complete with 6.81K ohm phantom power resistors and regurgitator balancing PCBs
The custom Neve case for the project.